Soundcraft Version 4.9.2 Service Release for all original Vi1, 2, 4 & 6 Consoles Now Available

This is to announce the availability of service release V4.9.2.306 for all Vi1, 2, 4 & 6 consoles.

This release primarily provides support for MSBi Stageboxes on the original Vi range, plus fixes to issues reported since V4.9.1 was released.


In order to ensure maximum stability, we recommend that this software is installed into all Vi1, 2, 4 & 6 consoles as soon as possible.

Bug Fixes & Improvements

  • MSBi Stageboxes are now supported (output cards were not showing up correctly on Vi consoles).
  • Vi1 could restart if two shows containing certain MIDI events were loaded sequentially.
  • MIDI Channel Selection could change from “IN1: CH1” to “NO DEVICE” after deleting Cues.
  • Vi1 ViSi Remote: L and R master faders are now linked as they are on the console, to prevent accidental L-R level offsets.

Note that the V4.9.2 software update cannot be installed on Vix00/x000 series consoles. The current V6.4.1 software information for these consoles is available here.

Offline Editor

An updated version of the Virtual Vi Offline Editor is also available incorporating the above bug fixes, allowing pre-programming of Show files

Show Compatibility

There are no known Show compatibility issues with this release

ViSi Remote iPad App

There is no change to the ViSi Remote app with this release

Where to get the software update

Downloads are now available on the Soundcraft website

From the ‘Software’ page in Products menu, scroll directly to required product

Update Instructions

Vi2,4 & 6
Please note that for Vi2/4/6, when upgrading to software 4.9.0 and above, the DSP and FX cards within the Local Rack must be fitted in the correct slots in order for audio to function correctly.

On software versions pre-4.9.0, this did not matter, and might have allowed cards fitted in non-factory default locations to go undetected.

Check the locations of your DSP and FX cards before performing the 4.9.2 update by referring to the Update Instructions documentUpdate Instructions document.

A document Checking DSP card positions in Vi Local Racks is also available from the website.

Vi1

Note that Vi1 consoles use a hibernation process to allow a fast boot, this means that a specific procedure has to be followed carefully when doing a software update.

Please download and read the Update Instructions here before starting the update

If you experience any issues or problems with the upgrade, please contact our Soundcraft Technical Expert